Lottie,
Hair&Postiche, Week 3
Buns&Plaits
Prosucts used
·
Fine tooth comb
·
Gown
·
Pins
Steps:
1.
Fill out consultation sheet
2.
Place gown around client
3.
Brush through hair
4.
Tie back in to a smooth pony tail at the back
of the head
5.
Section the hair in to 4, making sure that
each section is clean
6.
Start to create an inwards barrel curl with
the hair, then use a pin to secure the hair in place.
7.
Repeat this step on all four sections
8.
Once you have finished all four sections you
need to use a pin or the end section of your fine tooth comb to bring the hair
together making the bun complete.
9.
Use hair grips to secure bun in place
Hair pins are better for holding hair in place as they are
less visible in the hair.
PLAITS
French plait
Products used for
both:
·
Gown
·
Fine tooth comb
Steps:
1.
Place gown around client
2.
Brush through hair
3.
Section part of the hair using tooth comb
4.
Separate section in to 3 pieces
5.
Start by folding the outer sections over each
until you get to the third fold, this will create a tie in the hair to give the
hair a stronger structure.
6.
Now when you bring a section of the hair over
you should grab a small amount of hair each time, this will begin holding the
hair together
7.
Continue doing this until you have used all
of the hair, once you have reached the
nape of the neck continue plaiting the hair until you reach the ends of the
hair and tie with a hair band.
FISHTAIL PLAIT
1 .Gather all the hair together and create two sections
2. Take a small section from the outside of the first
section and fold it over the top into the second section with your thumb and
your second and third fingers.
3. Take a small section from the second section and fold it
over the top into the first section of the hair again with your thumb and your
second and third fingers.
No comments:
Post a Comment